Xenon Polarizer Gallery

Xeus Graphical User Interface showing advanced user operation

Lower gas handling Manifold with Alicat Pressure controllers and oxygen getters for each inlet gas.

Laser being aligned concentrically to the Aluminum Heating/Cooling Jacket which houses the SEOP Cell

Manual Operation - Using onboard NMR Spectrometer to acquire proton signal.

Magnet removed to show Laser with aiming beam on aligned to the SEOP cell and laser reflection optics.

Onboard IR Spectrometer signal being displayed on the Driver Module to ensure on resonance laser conditions.

Upper chassis open with electromagnet installed.

Electromagnet Removed to show components

Electromagnet Removed to show components

Automated Mode Running SEOP Process. In-situ NMR detection of Xe-129 during the build up process.

Displaying the Main Menu of the device on the Driver Module which gives access to all other menus.

The Main Menu allows you to control and have access to settings of individual components.

Under this menu will find 19 Automated procedures and sub-routines which are used to operate the device.

The menu stores all the SEOP Parameter for operating the device including max and min set point values used by the automated procedures and sub-routines.

Values of Calculated Parameters are stored such as the %Xe and rubidium polarization, build up rate, T1-decay, etc

Here you filled on all measured signals from the onboard devices such as IR and NMR data which are used for during the calculated parameters.

Here all settings relating to instrumentation and NMR settings are stored.

Here the system default settings are stored. This menu is used to update the device firmware.